the led ultra-thin wafer downlight from lithonia lighting. ultra-thin recessed downlighting with remote driver box for quick, simple, and housing free installations. there's no housing required. it's rated for wet location. ultimately, it can be installed anywhere. the led ultra-thin wafer downlight from lithonia lighting comes as a complete unit consisting of two parts: the led module and the remotedriver box. it's low profile design makes it the idealsolution for locations with shallow plenums. also included in the box is the installationinstruction sheet and a hole template
should a new hole be required in the ceiling. check that all the parts are included. the led ultra-thin wafer downlight easilyinstalls in the ceiling through direct wiring to a power source. the only tools needed for installation otherthan a ladder is a saw. a drill saw can be used for exact diameter. before you begin with the installation process,when working with electrical components, make sure you turn off the power at the main breakerand that your eyes are properly protected. double check and measure the size of the ceilinghole.
be sure it is the correct size for the outsiderim of the luminaire to cover the hole while still allowing the back of the luminaire tosecure to the ceiling with the spring folding firmly. if a new hole is to be cut, use the providedhole template or a drill saw with the diameter needed. mark your center and then cut the opening witha saw. pull electrical wire and cut length needed. open the cover of the remote driver box andremove one of the knockouts. locate the power supply leads from the remotedriver box and connect to power source using the provided wago connectors. connect the black wire to the live wire, white wire to neutral wire, and green wire to the ground wire.
secure each with the wago connector. be sure all connections are made inside thedriver box. close the cover of the driver box. place the remote driver box through the cutout hole and lay it on the ceiling. pull the spring clips on the fixture up andthrough the cut out hole. place the module in the hole, making surethe spring clips are holding securely. turn on the electricity at the circuit breaker box and walk back into the room where the fixture is installed. turn the power in the room back on and besure the module illuminates. this completes the installation of the ledultra-thin wafer downlight from lithonia lighting.